Comments on: What is Active band length?

By: Terry

Terry — Wed, 27 Dec 2023 16:27:38 +0000

Do you use the same formula to determine band length for all sizes of bands (for example .7mm thick vs. 1.0 mm thick, vs .5 mm thick)?

By: Team SimpleShot

Team SimpleShot — Mon, 02 Jan 2023 14:20:27 +0000

In reply to Foldan Abrori. Hello Foldan, It is not at all uncommon for the aiming point to be above the intended point of impact. There is a trajectory of the shot that must be accounted for, so the aiming point will usually be above the target!

By: Foldan Abrori

Foldan Abrori — Sat, 18 Jun 2022 20:13:47 +0000

Dear Nathan

I measured my draw length right excact at 15 cm (6″). But my aiming point is not at the center of target, but it’s below the target. Do you know what excactly happen and how do i correct it, so i can have aiming point at the center of the target.

Note: The target distance is 10 meters away from my shooting spot.

Best Regards,

Foldan

By: Malcolm

Malcolm — Wed, 08 Apr 2020 12:10:04 +0000

What would be the best width and taper on a six inch band length for 9mm BBC cheers

By: How can I measure my draw length? Copy | SimpleShot Academy

How can I measure my draw length? Copy | SimpleShot Academy — Wed, 19 Apr 2017 01:35:28 +0000

[…] length is your ‘draw length’ Knowing your draw length is critical to measuring your active band length, with is essential to accurately tune in your […]